Name: RAMPS 1.4 board
SKU: 7989
Price: 1750.00 ETB
Availability: InStock

RAMPS 1.4 board

Br 1,750.00

Ramps is a driver board designed for 3D printer, based on platform (firmware) Repap.
Standard interfaces (as that of extruder)
Reserved GCI like I2C and RS232
MOSFET 3 MOSFET are applied to the heater/ fan and thermistor circuit.
Another 5A added to protect the component parts.
An 11A fuse is added to the hotbed
Support 5 stepper drive board
The adoption of Pin Header as pololu makes it more convenient to repair or change.
I2C and SPI are reserved for expanding
All the MOSFET can be controlled by PWM
Use the interface of servo motor to adjust the level of printing platform automatically.
Adding a SD module for SD ramps module.
LED can indicate the status of the heater (the open and close of MOS).
2 stepper motor for Z axis in parallel.
Expandable to control other accessories.
Supply voltage: 12 V
Current consumption: minimum 5A (depending on the configuration, details on the wiki Ramps)
The system is compatible with Arduino Mega 2560
It requires five stepper motor drivers A4988
The system has the ability to connect limit sensors
Connector AUX for connecting additional elements, for example, Bluetooth module (details on the wiki Ramp)

RAMPS interfaces an Arduino Mega with the powerful Arduino MEGA platform and has plenty room for expansion.
It not only drives four steppers so you can design many types of machines based on it, like CNCand as a mature platform specially for 3D printer, it can also drive extruder, fans, temperature sensors, SD card, etc.
The RAMPS 1.4 board is an upgrade to v1.3 as it now uses surface mount LEDs, resistors, and capacitors
The modular design includes plug in stepper drivers and extruder control electronics on an Arduino MEGA shield for easy service, part replacement, upgrade-ability and expansion.
Additionally, a number of Arduino expansion boards can be added to the system as long as the main RAMPS board is kept to the top of the stack.
Six different resolutions: full step, half step, 1/4-step,1/8-step,1/16-step,1/32-step.
Fully assembled & tested, no soldering required
It is designed to fit the entire electronics needed for a RepRap in one small package for low cost
The modular design includes plug in stepper drivers and extruder control electronics on an MEGA shield for easy service, part replacement, upgrade-ability and expansion
A number of expansion boards can be added to the system as long as the main RAMPS board is kept to the top of the stack
Size: 11.5 x 6cm